Feig Electronic ID ISC.MR101-A Montageanleitung Seite 3

®
OBID i-scan
Wichtiger Hinweis:
Nichtbeachtung der nachfolgenden Hinweise
kann irreparable Schäden am Gerät zur Folge
haben.
!
•
Der Gerät
angeschlossenen
50 Ω ± 15 Ω <15° Antenne betrieben
werden!
•
Beachten Sie, dass Metallteile in der Nähe
der Antenne zu einer Verstimmung der
Antenne führen!
•
Bei der Pad-Antenne ID ISC.ANT340240
ist ein Mindestabstand von 20cm zu
Metallteilen einzuhalten!
Weitere Instruktionen müssen der detaillier-
ten Montageanleitung M50803 ....pdf ent-
nommen werden.
FCC ID PJMMR101-PR101
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received, in-
cluding interference that may cause undesired opera-
tion.
Warning: Any
changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate the equipment.
Installation with FCC / IC Approval:
FCC-/IC-NOTICE: To comply with FCC Part 15 Rules in the United States / with IC Radio
Standards in Canada, the system must be professionally installed to ensure compliance
with the Part 15 certification / IC certification. It is the responsibility of the operator and pro-
fessional installer to ensure that only certified systems are deployed in the United States /
Canada. The use of the system in any other combination (such as collocated antennas
transmitting the same information) is expressly forbidden. This device has been designed
to operate with the antennas listed below. Antennas not included in this list are strictly pro-
hibited for use with this device. The required antenna impedance is 50 ohms. An SMA
socket is provided on the circuit board for connecting the external antenna (ID ISC.MR101).
Table 1: Antennas with FCC / IC Approval (ID ISC.MR101)
FEIG ELECTRONIC GmbH
MONTAGE / INSTALLATION
darf nur mit
und abgestimmten
Article No.
1663.000.00
Important Note:
If you do not follow these instructions the
device hardware can be damaged irreparable.
!
•
einer Use this device only with a connected
and tuned 50 Ω ± 15 Ω <15° antenna!
•
Note that any metal parts around the
antenna can detune the antenna!
•
If the Pad-Antenna ID ISC.ANT340240 is
used, keep a minimum distance of 20cm
( 8 inch ) to any metal parts!
More instructions must be read in the de-
tailed mounting instruction M50803 ....pdf.
IC Certification Number: 6633A-MR101
This Class B digital apparatus complies with Cana-
dian ICES-003.
Part No.
ID ISC.ANT340/240
ID ISC.MR100-A / ID ISC.PR101-A
M50804-3de-ID-B.doc