General Settings - Phonocar VM022 Gebrauchsanweisungen

Settings
EN
AUDIO
Briefly press the VOLUME KNOB (4) to enter the menu of audio settings and briefly press again.
the knob (4) to scroll through the list of available audio settings:
BASS-TRE (high/low tone adjustment)
BAL L-R (balancing)
FAD F-R (fader)
LOUD ON/OFF (loudness)
EQ (EQ OFF, ROCK, FLAT, CLASS, POP)
To adjust, turn the knob to the requested value.

GENERAL SETTINGS

Press the knob (4) for 3 seconds to enter the menu of generic settings and briefly press the knob (4) again to
scroll through the list of available generic settings:
COLOUR (auto/blue/green/red/light blue/yellow/violet/white)
BEEP (on/off)
CLOCK (24/12)
P VOL (default base volume)
LOC (on/off - local/distance)
STEREO/MONO.
To adjust the wished setting, turn the VOLUME KNOB (4) to the requested value.
CLOCK 24/12
Set the time in 24-h or 12-h version
CLOCK
Press the DISP/0 (13) key several times until the time is shown on the display.
Press the DISP/0 (10 key for 3 seconds, the time will begin to flash. Set the desired time by rotating the VOLUME
KNOB (4), then briefly press the volume knob (6) and turn it to adjust the minutes, then press again to confirm.
When the time stop flashing, the setting is complete.
P.VOL
This function sets the volume level at the power on.
DX/LOC (Distant/local)
LOC ON: Reduces the sensitivity of radio reception when searching for stations, so only stations with a good signal
are found.
LOC OFF: The sensitivity of the radio reception is at its highest level and all the stations will be found, both with
good and poor signal.
9