Technical Data; Getting Started - Targa LLR 58 A1 Bedienungs- Und Sicherheitshinweise

[5] Light stand (upper section)
[6] Light stand (lower section)
[7] Tube holder for light stand
[8] On/Off button
The illustration is not to scale.

Technical Data

Operating voltage:
Illuminant T8, 58W:
Permissible
ambient temperature:
Safety Class:

Getting Started

Selecting a Site
You can attach the light to a wall or ceiling.
Using the stand, you can also use the light
in an upright position. When choosing the
site where the light is to be installed, bear in
mind the following:

Ensure that
disconnected from the socket outlet in
case the light has been switched on
before.

There should be no flammable material
near the installation location (e.g.
curtains, streamers or similar).

There should be an available socket
outlet near the installation location. The
socket outlet must be easily accessible
so that the mains cable of the light can
be pulled
dangerous situation.

Ensure that the surface that the light is
to be attached to is stable. If the lamp
tips over or falls new dangers may
arise.
230 V~ 50 Hz
Fluorescent tube
max. 30 °C
II
the mains plug
out immediately
Attaching the mounting clips
We recommend using the enclosed screws
and rawlplugs for the installation. If you
wish to attach the light to a plasterboard
wall, you will need to use specially
designed cavity fixing rawlplugs. If you are
unsure as to which fixings will be sufficient,
consult a specialist.

Drill two holes using a 6mm drill bit.
The holes must be 110cm apart from
each other.

Insert the rawlplugs (3) into the drilled
holes.

Insert the screws (2) through the holes
in the assembly clips (1) and screw
them firmly into the rawlplugs.

Rotate the mounting clips so that the
openings are positioned in the same
direction.

Carefully place the light on to the clips
until the housing is surrounded.
Take care as the light will become
is
warm when it is in use.
If you wish to remove the light from
the clips (e.g. in order to clean it)
ensure that the clips are still stable. In
any case retighten the screws.
Installing with the Stand

Lay the upper section (5) of the stand
crossways over the lower section (6) of
the stand. Make sure that the upper
section of the stand has a higher
in a
shape than the lower section. The
upper and lower sections should not
be assembled the other way round.
The holes in the base sections must
coincide with one another.
14