S&P HCM-150N Bedienungsanleitung Seite 5

ENGLISH
HCM Wall / Panel Mounted Axial Fans.
The HCM range of wall / panel mounted
axial fans have been manufactured to
the rigorous standards of production and
quality control in accordance with the
International Quality
9001. All components
checked and tested at the end of the
manufacturing process.
All appliances are supplied in perfect
condition and operation. However if
found to be defective the unit should be
returned to the supplier in accordance
with the terms of the S&P guarantee. We
recommend that you check the following
when receiving this product:
1. That it is the correct size and model
type.
2. That the details on the rating label are
those required: voltage, frequency...
IMPORTANT SAFETY NOTES.
- All installation
connection work should be carried out
in accordance with all applicable
National and Local Building Code
Regulations pertaining to the country
of installation.
- All installation
connection work must be carried out
by suitably
person(s).
- If the fan is proposed to be installed in
a system or environment where a gas
or other
appliances are present, then it is the
installers responsibility to ensure that
sufficient air make-up is provided for
the heating appliance to operate
correctly.
- The fan should be connected to the
electrical supply with correctly sized
cables and should include a double
pole switch with a contact clearance of
at least 3mm.
Standards
have
and electrical
and electrical
qualified professional
combustible heating
- All HCM fans are incorporate Class II
(double)
connection is therefore required.
- The HCM series of fans are designed
to extract air up to and including the
maximum air temperature as detailed
ISO on the rating label. Please check
been before installation.
- The HCM series of fans are designed
for general ventilation use only. Do
Not Use To Extract Hazardous or
Potentially Explosive Materials and
Vapours.
INSTALLATION
Before any installation ensure the fan is
isolated and disconnected from the
mains electrical supply.
Mounting the fan in glass or a panel
(maximum thickness 8mm)
- First cut a circular hole in the glass or
panel in which the fan is to be
installed.
accordance with the HCM model size
as indicated in Figure (A1).
- Figure (B). Remove the interior grille
(1) from the fan casing by loosening
the fixing screw (3).
- Remove
shutters) by removing the interior
plastic fixing nuts (6).
- Separate the fan casing (3) from the
exterior grille (2).
- From the outside, position the exterior
grille through the hole in the glass /
panel and fix into position (from inside)
using the grille retaining lugs (4).
When in position, twist lugs around to
fix.
- From the inside locate the fan casing
(3) through holes provided for exterior
grille threaded rods (7). Fix the interior
plastic nuts (6) onto the threaded rods
to secure the fan casing to the exterior
grille. The glass / wall should be
insulation. No
Cut the hole
the exterior grille
earth
size in
(with