Arcam FMJ AV8 Bedienungsanleitung Seite 36

GENERAL OPERATION COMMANDS
Command Parameters
PWR ?zPWRx
MUT ?zMUTx
FAN zFANx
EFF ?EFFy
THX ?THXy
DEC ?DECy
DIS
RES
INF
SIG ?zSIG
STS ?zSTS
TRM TRMsy
MAIN MENU COMMANDS
Command Parameters
VOL ?zVOLy
PRE PREy
AUD ?zAUDi
VID ?zVIDi
VDT VDTy
DIR ?DIRix
BAL BALy
RCT RCTi
RCV RCVi
COM COMy
LIP LIPy
DIM DIMy
CTW CTWy
PAN PANx
HED HEDz
Description
Power on/off
Mute on/off
Force Analogue
Effect Mode Selection
THX Mode Selection
Decode/Downmix Mode Selection
VFD Display
Restore Preset
Current Source information (on OSD)
Current Audio Signal Type
Zone Status. Displays current state of
Audio,Video,Volume, Mute, Audio Signal
Type, *Decode/Downmix Mode, *Effect
Mode, *THX Mode.
* Zone 1 only
Trim Levels
Description
Volume
Preset Select
Audio source selection
Video source selection
Video Type
Stereo Direct
Balance
Record To Tape Select
Record To VCR Select
Compression
Lip Sync Control
Pro Logic II MusicMode Dimension
Pro Logic II Music Mode Centre Width
Pro Logic II MusicMode Panorama
Headphone Out
E-36
Parameter values
y may have the values 0 to 7, as follows:
0 = off, 1 = music, 2 = party, 3 = club, 4 = hall, 5 = sport, 6 = church, 7 = next
effect.
y may have the values 0 to 4, as follows:
0 = Off, 1 = THX Cinema, 2 = THX Ultra2 Cinema, 3 = THX MusicMode, 4 =
THX SurrEX.
If Audio Signal Type is Analogue or PCM, y may have the values 0 to 6 as follows:
0 = Mono, 1 = Stereo, 2 = Pro Logic II Movie, 3 = Pro Logic II Music, 4 = Pro Logic,
5 = Neo:6 Cinema, 6 = Neo:6 Music.
If Audio Signal Type is Digital Surround (Dolby or DTS), y may have the values 0 to
2 as follows:
0 = Mono Downmix, 1 = Stereo Downmix, 2 = No Downmix.
y may have a value in the range -10 to +10:
-10 = –10dB
+10 = +10dB
Parameter values
y may have a value in the range -53 to +19:
-53 = –53dB
+19 = +19dB
y may have a value in the range 1 to 5.
y may have the values 0 to 1, as follows:
0 = 4:3, 1 = 16:9.
y may have a value in the range -10 to +10:
-10 = +10dB to Left
+10 = +10dB to Right
y may have the values 0 to 2, as follows:
0 = Off, 1 = Medium, 2 = High.
y may have a value in the range -1 to +44:
-1 = –5ms
+44 = +220ms
y may have a value in the range 0 to 6.
y may have a value in the range 0 to 7.
E-36