Installation - Klarstein 10034117 Bedienungsanleitung

EN
14

INSTALLATION

Before initial start, keep the refrigerator still for 30 minutes before connecting it to power
supply.
• The appliance should not be tilted more than 45 degrees when you move it. Do not
use force on any part such as the condenser, the door or handle. They could distort
and affect the operation of the cooler. Ensure ALL packaging is removed before
installation.
• Make sure there is enough ventilation space around product.
• The appliance should not be installed near external heat sources e.g. direct sun shine
or external moisture sources.
• Ensure the supply voltage of socket is same as rating label.
• The plug must be properly inserted to the wall socket.
• The mains supply socket must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord.
• The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
• Do not move or tilt the refrigerator while it is in operation.
• Make sure that there are no objects near the refrigerator that could be damaged
by heat. The condenser coils located in the refrigerator walls can become very hot
during normal operation.
• Do not place heavy objects (including the refrigerator) on the power cord.
Note: Do not site the product where the ambient temperature is likely to drop below
5 °C - e.g.: garage or shed.