ULTIMATE SPEED 220 106 51 Anwendungs Und Sicherheitshinweise Seite 57

Insert the desired device and press
n
against the clamp
the device will simply be held by the
holder
from the clamp so that the device is
pressing against the holding tabs and is
therefore locked. Place the device so that
all side operating elements remain freely
accessible.
To remove the device, simply press it
n
against the clamp
then remove the device at a slight angle.
The holder
thanks to the ball joint
installed can be put in various positions
e.g. vertical (for instance for use as a
camera) or horizontal (for instance for
the satnav function). On the back of the
holder
with which a charging cable may be
attached (cable not supplied with the
holder).
Cable clips: narrow cable clip for cable
thicknesses of 2.4 - 3.0 mm wide cable
clip for cable thicknesses of 3.5 - 4.1mm
8_322267_1901_INT_Smartphonehalter_OSDE_OSNL_OSBE_OSCZ_OSGB_OSPL_OSSK
. Now remove the pressure
^
can rotate through 360°
^
there are two cable clips
^
. This will give and
\
again until it gives,
\
, so the device
5a
·
07.06.19 17:0