Before Use - LIVARNOLUX HG01089 Bedienungs- Und Sicherheitshinweise

Always check the appliance and the mains supply for damage
before connecting it to the mains. A damaged device represents
the danger of death from electric shock.
Do not use the device if you detect any damage.
The power cable cannot be repaired! Should the cable be
damaged, the product must be rendered useless and must be
disposed off appropriately.
Prevent fire and
injury hazards
RISK OF BURNS! Ensure that the luminaire has
been switched off and has cooled before touching
it, to avoid burn injuries.
CAUTION! RISK OF FIRE! Never expose the
magnifier to direct sunlight or other light sources.
Never leave an open magnifier unattended. Doing
so presents a fire hazard due to bundled light rays and con-
centrated heat.
The product may only be used with the built- in LED control gear.
The illuminant is not replaceable.
If the illuminant fails at the end of its life, the entire light must
be replaced.
The product continues to draw a small amount of power even
if the lamp is off as long as product is connected to supply
mains. To switch the device off completely, the mains switch
should be switched off.
Please note the lamp is not dimmable.

Before use

Insert the screw clamp into the bracket
screw clamp into the bracket using the lock screw
Now place the screw clamp onto a table top ≤ 6 cm in thickness
and secure the screw clamp by turning the screw clockwise
(Fig. C).
Insert the articulated arm
and secure by tightening the wing bolt
Verify the articulated arm is firmly tightened in the bracket.
28 GB/MT
1
into the round hole on the bracket
7
5
(Fig. A). Secure the
(Fig. B).
3
clockwise (Fig. D).