Installation - Mazzoni KB4000 Gebrauchs- Und Wartungsanleitung

KB4000/KB4050/KB4025/KD4000/KXSB15500
1
) Check the oil level that must always be higher than the rod notch both in the
motor and in the pump. As concerns the motor, please refer to
Honda manual or Lombardini manual(KD4000)or Loncin manual ( KB4025)
4) Connect the water supply hose (the inner diameter must be not smaller than 14
mm) to the pump inlet fitting (A). Make sure that the suction filter of the suction
fitting is always clean. The dirty filter causes a bad water supply and
consequently a very bad pump operation with the inevitable risk of a rapid
wearing out and breakage of the internal mechanisms.
Preliminary operations before starting to use the machine: connect the machine to the water tap
and the electrical socket, then open the water tap and let the water flush out from the high pressure
hose for a few minutes to eliminate water impurities which could block the nozzle. Close water tap,

INSTALLATION

2)check that the tank is properly
filled with g asoline or diesel
(KD4000)
3) Connect the high pressure hose
to the outlet fitting (B), tightening the
ferrule completely and the other end to
the automatic gun (C).
B
A
22
C