Locomotive Address - roco 10735 Bedienungsanleitung

Locomotive address

The factory-set default address of the Decoder is 03. To programm a new address please refer to the Lokmaus
manual or the Instruction Sheet of your digital system.
Programming for the Decoder
See multi MAUS/Lokmaus -Manuel.
Operation on analog layouts
A ROCO locomotive equipped with a Decoder can also be run on a conventional layout. To change direction
of travel the control knob of the controller must first be set to zero. Only then can the direction of travel be
selected. The brightness of the lamps depends on the speed of the train. The lights can not be turned off.
Reprogramming of previously set addresses and functions is not possible while in analog operation.
List of supported CVs
The following list informs about the programming capabilities of the Decoder. We recommend to test your locomo-
tive / railcar with regard to starting voltage, acceleration, braking and maximum speed during operations to check
if these characteristics are set conforming to your wishes BEFORE changing the factory-set default settings.
CV-Nr. use
01 locomotive address
02 starting voltage/minimum speed 00 – 255*
03 acceleration
04 braking
05 maximum speed (digital only)
06 maximum speed/load regulation
(conventional layouts)
07 number of decoder version
08 Manufacturer's ID
29 Configuration register
6
8010735926 VII_2008.indd 6
bandwith of possible changes
1 – 99 ( multi MAUSLokmaus 2, R3)
sonst bis 127
00 – 63
00 – 63
00 – 255*
00 – 255*
only reading!
only reading!**
00 – 63
2
®
werkseitige
Einstellung
3
3
2
2
0
0
>33
157
6
23.05.2008 07:46:14