Blaupunkt Florida RD 168 Einbauanweisungen Seite 6

Connecting diagrams
Vehicles without car radio prefitting .......................................... Fig. 4
Power supply to standard ISO connectors ................................ Fig. 5
Power supply to car-specific connectors ................................... Fig. 6
Loudspeaker connection 4x 4Ω/40 watts .................................. Fig. 7
Equalizer or amplifier connection, (CINCH) ................................ Fig. 8
LF = left front, RF = right front
LR = left rear, RR = right rear
blue
yellow
This information is subject to change without notice!
+12V
Out
IN
red
black
IN
IN
1 2 V
Control cable (power antenna +)
The control cable is the positive switching output for external
components, e.g. power antenna (max. load < 150 mA).
Do not connect the control cable to terminal 15 (positive switching
line) or to terminal 30 (constant power).
Relais
Positive connection (switched via ignition)
If you connect the positive cable of the fuse holder (terminal 15)
behind the fuse, you can turn the car radio on and off with the
ignition.
Kl.15 +12V
Ground connection
Do not connect the ground cable (min. cross-section 1.5 mm
the negative terminal of the battery.
Connect the ground cable to a suitable ground spot (car body
screw, car body sheet).
Illumination connection
Connection for vehicles with adjustable instrument illumination
(pulse controlled).
Constant power terminal (terminal 30 battery +12 V)
Lay the positive cable (yello) with large cross-section (min.
2
1.5 mm ) to the battery (do not route any cable close to a wire
harness). Attach the fuse holder to protect the positive
cable and connect it to the positive terminal of the battery.
Fig. 4
- 6 -
2 ) to
8 622 401 541