OmniMount Systems VT-2 Aufbauanleitung Seite 3

Step 6
Rock the video table to check that it is level and stable.
Note: Un-screw shortest foot until table sits level.
Step 7
Slide Lower Glass Shelf into place over bottom Support Members. (Fig. 6)
Note: Make sure rear of shelf touches Back Post.
Step 8
Place Top Glass Shelf over table assembly, with Aluminum Caps aligned over
Aluminum Cups. (Fig. 7a)
Note: First lower front of glass shelf into front cups, and then lower rear of shelf
into rear cup. Slide rear cup under shelf as required for proper alignment.
Install Set Screw (R) into Front Aluminum Cups, and tighten securely. (Fig. 7b)
WARNING: DO NOT MOVE TABLE BY LIFTING ON THE TOP SHELF. ALWAYS MOVE TABLE BY GRASPING THE FRAME.
Step 9
Route cables through Cable Management Ports, and down Back Post.
Align Back Cable Cover (S) with top edge of back post.
Snap cover into place. (Fig. 9)
OmniMount Systems, Inc.
8201 S. 48 th St. • Phoenix, AZ • USA
www.omnimount.com
Fig. 6
Fig. 7a Fig. 7b
Fig. 9
3