OmniMount Systems VT-2 Aufbauanleitung Seite 2

Step 3
Place Back Post over ends of Support Members. (Fig. 3a)
Secure Back Post using supplied 5mm Long Hex Bolts (K). (Fig. 3b)
Securely tighten all Hex bolts on frame assembly.
Step 4
Fig. 4a
Step 5
Locate 2 front Aluminum Cups with set screw holes (O). Secure cups to mounting holes at end of Main Frame with 6mm screws (J). (Fig. 5a)
Note: Set screw holes should face outside of frame.
Attach Self Adhesive Rubber Pads (P) to bottom Support Members.
Note: Position pads 2 inches from Main Frame and Back Post. (Fig. 5b)
Place rear Aluminum Cup (L) over hole in top of Back Post. Loosely secure cup with 6mm hex bolt (J). (Fig. 5c)
Note: Cup should be able to move forward and backward when secured.
Secure Grooved Aluminum Cap (Q) into mounting hole at front center of Main Frame with 6mm screw
Fig. 5a
2
Fig. 4b
Screw Threaded Connectors (F) in to holes on Aluminum Discs (H) to create Foot
Assemblies.
Screw Foot Assemblies into holes on bottom of Main Frame and Back Post. (Fig. 4a)
Stand table frame assembly upright. (Fig. 4b)
Fig. 5b
OmniMount Systems, Inc.
8201 S. 48 th St. • Phoenix, AZ • USA
www.omnimount.com
Fig. 3a
Note: Thread Foot Assemblies fully into frame.
(Fig. 3b)
Fig. 5c