Product-Specific Safety Instructions; Operation; Inflating The Product - OWIM Z31427 Bedienungs- Und Sicherheitshinweise

DANGER TO LIFE! Never
modify the product.
CAUTION! DANGER OF INJURY! Please
verify no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could result in injury. Damaged parts could
impact safety and function.
½
Be sure the product is only assembled by
skilled persons.
½
Never use the equipment/product if
damaged.
Product-specific
safety Instructions
½
DEATH DUE TO DROWNING!
Never leave children and non-swim-
mers unsupervised with the product or in the
water. Risk of death due to drowning. Be sure
at least one skilled person is present.
DANGER TO LIFE! Never
allow non-swimmers to enter the product with-
out flotation devices. Be sure all persons wear
a life jacket.
DANGER TO LIFE!
½
Only use the product in shallow, protected
waters or ponds at least 30 cm deep.
½
Be sure there are no obstacles in the water, such
as rocks. Do not use the water in strong winds
and/or currents.
½
Never use the product in white water. Familiar-
ise yourself of the waters before use.
½
CAUTION! Be sure not to over-inflate the
product. The product may otherwise burst.
CAUTION! RISK OF POISONING AND
PROPERTY DAMAGE! Do not light fire near
the product and keep it away from heat
sources.
½
Regularly check all accessories and materials
for wear and/or other damage.
½
Please note this is a seasonal product. Properly
store the product when not in use for extended
periods.
½
80kg
result in injury and / or product damage.
½
Never tow the product with other boats and /
or vehicles.
½
Do not dive from the product.
½
Be sure not to have sharp or pointy objects on
you when using the product or whilst in it. The
product may otherwise be damaged.
½
Never transport the inflated product on the car
top.
RISK OF INJURY! BEWARE OF OFF-
SHORE WINDS AND CURRENTS.
½
The boat should be protected from contact with
liquids such as battery acid, oil or petrol.
RISK OF

Operation

Note: Carefully inspect the product for holes,
porous areas and leaking seams prior to first use.
Inflating the product
Note: Inflate the air chambers in the correct order.
CAUTION! Inflatable plastic products are sensitive
to the cold. Therefore do not use the product in out-
door temperatures below 15°C. The product may
otherwise be damaged.
First identify a suitable location to inflate the
product.
CAUTION! Be sure the ground is even and
away from boulders and pointy objects. The
product may otherwise be damaged.
Unroll and inspect the product for holes, tears
and other damages (see Fig. A).
Tip! Place the product in the sun for 2 hours
before inflating. This will warm up the material,
making it softer.
Screw the screw-on valve
the respective openings. Unscrew the top cap
counter-clockwise (see Fig. C III).
Note: Inflate the individual air chambers one
by one - never at once - initially to approx.
Do not exceed a load of 80 kg. Be
sure to evenly distribute the weight.
Failure to observe this advice may
clockwise onto
12
GB 7