Troubleshooting - Buffalo GD230 Bedienungsanleitung

Telephone Helpline: 0845 146 2887 (United Kingdom)
Note: The appliance has a maximum temperature setting of 110°C.
Cleaning, Care and Maintenance
• Always turn off the appliance and disconnect from the power supply before cleaning.
• Allow the appliance to cool before cleaning.
• The inner body of the appliance should be wiped down at the end of each day's operation. Additional
cleaning may be required depending on frequency of use.
• The crumb tray, wire racks, display panel and glass doors can be removed and washed if necessary.
• Warm soapy water is recommended for cleaning. Cleaning agents may cause damage or leave harmful
residues when used for a prolonged period on stainless steel.
• A Buffalo dealer or qualified technician should carry out repairs if required.

Troubleshooting

If your Hot Display Cabinet develops a fault, please check the following table before making a service call.
Fault
The unit is not heating
up and the indicator
light is off
The unit heats up but
the indicator light is off
The unit is not heating
up or heats up slowly
and the indicator light is
on
The lamp does not light
Telephone Helpline: 0845 146 2887 (United Kingdom)
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The thermal cut out is
working
Indicator light is faulty
Incorrect operation
Thermostat failure
Element failure
Thermostat displays wrong
temperature
The lamp has failed
The starter has failed
The rectifier has failed
Action
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Ensure that thermostat has been set correctly,
doors are closed and the thermostat sensor bulb
has not been removed or damaged
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
Replace the lamp
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician