Mazzoni K1000 Gebrauchs- Und Wartungsanleitung Seite 22

K1000
A
3) If the mains voltage corresponds to the indications on the label fixed on
the motor, you can plug the unit in. It is prohibited to use extensions or
loose plugs not to standards.
The electrical system the appliance is connected to must be made in
conformity with the laws in force in the country of installation.
It is recommended to have a differential thermomagnetic switch, with
sensitivity equal to 30 mA, upstream from the power socket.
Preliminary operations before starting to use the machine: connect the machine to the water tap
and the electrical socket, then open the water tap and let the water flush out from the high pressure
hose for a few minutes to eliminate water impurities which could block the nozzle. Close water tap,
connect gun and lance and start to work.
INSTALLATION
1) Connect the high pressure hose to the
2) Connect the water supply pipe
B
WARNING:
The earth connection is compulsory
outlet connection (A).
(diameter not lower than 14 mm) to
the pump inlet connection (B). Make
sure that the suction filter of the suction
hose connection is always clean. The
dirty filter causes a bad water supply
and con se q u e n tl y a bad pump
operation with the inevitable risk of
rapid wearing out and breakage of
internal mechanisms.
.
23