Pico Technology
CAUTION:
•
To avoid damage, do not use the transducer in long-term or permanent installations
such as installed monitoring systems in vehicles. The WPS600C is intended for
immediate diagnostic purposes only.
•
To avoid measurement errors do not use the transducer with the charging cable
connected.
•
To avoid incorrect readings and possible equipment damage, do not operate this
transducer in wet or damp conditions, or submerge it in liquid. The transducer is
splash-resistant but not immersion-proof.
•
To avoid further damage, have a suspected damaged transducer inspected by
qualified service personnel. Do not attempt to dismantle or repair it yourself.
•
To avoid damage to the lithium polymer (LiPo) battery inside the transducer, do not
store or operate the unit above 60 °C (140 °F).
1�2
Compatible fluid types
The WPS600C is designed for use with hydraulic oils only. Do not use it with gases or
any other type of liquid.
Remember:
•
ALWAYS safely depressurize the system under test before you connect the transducer.
•
ALWAYS check that the pressure connector is securely fastened to the transducer BEFORE
you pressurize the system. If there is any sign of a fluid leak from the transducer once you
have pressurized the system, always depressurize the system before attempting to correct it.
DO NOT disconnect the transducer or the high-pressure hose from a pressurized system.
•
The WPS600C battery is not field replaceable. If a problem occurs with it, please return the
transducer to the manufacturer for repair.
1�3
Power supply
Type
Charging current
Charging connector
Ambient operating
temperature
Ambient storage
temperature
Environmental
protection
Compliance
DO298-2
Built-in LiPo battery, not user-serviceable
500 mA (max.) at 4.75 V to 5.25 V from USB charger cable
USB mini
60 °C (140 °F) max.
60 °C (140 °F) max.
Splash-resistant against water, gasoline, diesel and hydraulic fluids.
Not immersion-proof.
CE, FCC Part 15 class A
Safety information
2