Vooni FINGERPRINT LOCK Bedienungsanleitung Seite 5

RECORDING ADDITIONAL FINGERPRINTS
1. Long press on the sensor 2. When the blue light
for 3 seconds, until the blue flashes continuously, admin-
light flashes istrator authorization is
needed – the administrator
puts the finger with the
first recorded print on
the sensor
3. Start to record a new
fingerprint when the light
flashes green by holding
your finger on the sensor
for a couple of seconds.
4. Lift up and then put down
your finger on the sensor
again. Record 10 times with
the same finger to get a de-
tailed recording of the print.
The blue light indicates a
recording was successful,
while a red flash indicates
that the recording was un-
successful. If unsuccessful
– just place your finger on
the sensor again and repeat
the recording.
EN
5. When a total of 10
recordings were successful,
the green light will flash and
you will hear a sound to
indicate that the fingerprint
was successfully recorded
and stored.