Vooni FINGERPRINT LOCK Bedienungsanleitung Seite 4

EN
RECORDING ADMINISTRATOR FINGERPRINT
The lock can store up to 10 different fingerprints. The first and second fingerprints are considered as administrator
fingerprints by default. Collecting the second to tenth prints requires authorization by administrator fingerprint.
Make sure to position the tip of your finger so it covers the whole sensor.
To record the very first fingerprint, follow these steps:
1. Long press on the sensor for 3
seconds, until the blue light flashes
2. When the green light flashes,
start to record the fingerprint by
holding your finger on the sensor
for a couple of seconds
3. Lift up and then put down your
finger on the sensor again. Record
10 times with the same finger to get
a detailed recording of the print.
The blue light indicates a recording
was successful, while a red flash
indicates that the recording was
unsuccessful. If unsuccessful – just
place your finger on the sensor
again and repeat the recording
4. When a total of 10 recordings
were successful, the green light
will flash and you will hear a sound
to indicate that the administrator's
fingerprint was successfully
recorded and stored