Denon Professional CONVOY Benutzerhandbuch Seite 6

9. USB Charging Port: Connect your device's charge cable here to charge it. USB charging
only functions when the unit's power is turned on.
Note: To charge smartphones and tablets faster, put the device's screen to sleep.
10. Power Switch: Use this switch to power the loudspeaker on or off. Make sure all Volume
knobs are set to "zero" before powering it on. When the loudspeaker is powered on, the
Power LED above it will be lit.
11. Charge Indicator: This LED will illuminate when Convoy is connected to AC power to
indicate it is charging. Once charging is complete, the LED will go off.
12. Battery Level Indicator: While the unit is powered on, these four lights indicate the power
left in the battery. Battery life varies based on volume and usage.
13. NFC (Near-Field Communication) (top panel): Touch and briefly hold your supported and
enabled device to the NFC logo to pair the device. See
NFC for more information.
Rear Panel
UHF MODULE – GROUP 1
2
UP
PAIR
DOWN
3
1. Power Cable Input: Insert the included power cable here to charge the unit. Please note
that when the power cable is connected, the battery will still charge while the unit is in use.
2. Display: Shows the selected wireless mic group or channel.
3. Wireless Receivers: Sync wireless transmitters such as the included hand-held
microphone to these receivers. Use the Up/Down buttons to select a channel. Press the
Pair button to link the channel to the wireless transmitter. See
Microphone Setup
Note: The left side UHF module is always set to Group 1 and the right side UHF module is
always set to Group 2.
4. RF/IR LEDs: The RF LED illuminates when a wireless mic frequency has been matched to
your wireless microphone. The IR LED will illuminate when the Pair button is pressed and
the receiver pairs to your wireless mic.
6
4
for more details.
Pairing a Bluetooth Device Using
1
UHF MODULE – GROUP 2
2
4
UP
PAIR
DOWN
3
Operation > Wireless