Wall Mounting - switel COIP200B Bedienungsanleitung

Installation
Inserting memory card and batteries
1. Slide lock in direction of arrow and open cover.
2. Insert micro SD card (not supplied / up to 128 GB, FAT
formatted) into the card slot "TF" (contacts face down).
To remove the micro SD card push it a little way into the
slot. ATTENTION! It is then ejected with spring pressure.
3. Insert 4 x AA batteries (not included) as shown (observe
polarity!)
4. Close the cover and make sure that the lock closes
correctly.
Note: You can also use the camera with rechargeable batteries (type AA / reasonable
capacity > 2500 mAh) - these can be charged via the supplied micro USB cable when
installed.
• Always use batteries or rechargeable batteries of the same type.
• Never mix batteries and rechargeable batteries. Always exchange the
complete set.
Operation with an external power supply is also possible with the supplied micro USB
cable. In this case, we recommend leaving no (non-rechargeable) batteries in the
camera. Make sure that the cable is securely routed and that the mains socket in which
the charger is located is freely accessible in order to be able to disconnect the device
from the mains quickly if necessary.

Wall mounting

1. Attach the bracket to a wall. When drilling, make sure that you do not damage pipe or
power lines.
2. Place the camera (magnetic surface) on the bracket and align it.
GB
9