Preparing The Appliance For Operation - GS F 245 Betriebsanleitung

GB
DESCRIPTION OF THE APPLIANCE, BASIC PARTS (fig. 1)
IMPORTANT! THE APPLIANCE ACCESSORIES LISTED BELOW MAY DIFFER FROM THE ACCESSORIES
OF THE APPLIANCE YOU HAVE BOUGHT IN QUANTITY AND IN DESIGN. THIS DESCRIPTION IS
ADAPTED FOR ENTIRE GROUP OF FREEZERS.
2 Fast-freeze indicator
3 Thermostat position indicator
4 Electric supply indicator (green light)
5 Thermostat - temperature regulator
6 Temperature rise indicator
CONTROL PANEL — DESCRIPTION OF SYMBOLS AND OPERATIONS
2 ― FAST-FREEZE INDICATOR, marked with the symbol
on, the yellow indicator light is illuminated. Instructions on how to use the fast-freeze function
are in the section entitled "Freezing of food stuffs in the freezer compartment".
ATTENTION!
The fast-freeze function does not turn off automatically — it needs to be switched off!
When the fast-freeze mode is on, the appliance's compressor works non-stop.
3 ― THERMOSTAT POSITION INDICATOR, marked with the symbol
is seen on the thermostat position indicator.
4 ― ELECTRICITY SUPPLY INDICATOR, marked with the symbol
connected to the electricity supply, the green indicator light is illuminated. Simultaneously also the
the temperature rise indicator lights up. It indicates that the freezer was switched off for a
longer time, i.e. the freezer is switched on for the first time, after defrosting or after losing
voltage. When the temperature in the compartment again falls below -9 ºC, the indicator light will
go out.
6 ― THE TEMPERATURE RISE INDICATOR is marked with the symbol
temperature in the freezer compartment rises above -14 ºC, the red indicator light is illuminated.
It indicates that:
x The freezer was switched off for a longer time, i.e. the freezer is switched on for the first time,
after defrosting or after losing of voltage.
x The door of the freezer is opened or is being opened too frequently.
x It is loaded a large amount of unfrozen foodstuffs.
x The freezing system is failed, i.e. the indicator does not go out longer 6 hours and it
is heard running compressor or the compressor does not switch on. In this case you
should apply to your service agent (at first make sure that three above items were
taken into account).

PREPARING THE APPLIANCE FOR OPERATION

! It is recommended to prepare the appliance for operation with a helper.
x Remove package. Lift the appliance away from foamed polystyrene base. If your freezer is fit
with screwed handles. Do not rise or push it taking by handles. Handles may break.
x Tear off adhesive tapes.
x When positioning the appliance in chosen location, it will move more easily into position if you lift
the front a little and incline it backward, allowing it to roll on its casters.
x Remove the support from the bottom cover (fig. 2). Tear away the red-coloured
from the door trays – they are intended only for the transport of the appliance.
x Suitably dispose the packaging material.
x Take two supports from the bag and insert them into the guides at the top back part of the
appliance (fig. 3).
REVIEW OF MECHANICAL CONTROL (fig. 1)
7 Fast-freeze section (s)
8 Frozen products section(s)
9 Condenser
10 Compressor
11 Cold accumulator
When the fast-freeze mode is turned
-
9
5
The thermostat position
When the appliance is
When the
adhesive tapes
of