Starting Up; Safety Notes; Checking The Package Contents; Inserting Batteries (Not Included In Material Supplied) - AUDIOLINE AB 820 Bedienungsanleitung

Starting Up

3 Starting Up

Safety notes

It is essential to read the Safety Information at the beginning of this manual before starting
up.

Checking the package contents

The package contains:
an answering machine
a telephone connection cable

Inserting batteries (not included in material supplied)

Before connecting the answering machine to the telephone network, insert a new 9 V battery. In the
event of a power failure, the battery will ensure data is retained for approx. 24 hours.
As soon as the red LED is flashing, the battery is empty and must be replaced.
Pay attention that the answering machine is not connected to the telephone network at this point.
1. Use a small screwdriver to open the battery compartment on the underside.
2. Connect the battery plug to the battery and insert the battery in the battery compartment.
3. Close the battery compartment cover.

Connecting the telephone line and power adapter plug

1. Insert the small plug on the power adapter plug cable in the corresponding socket on the rear
side of the answering machine.
2. Insert the small plug on the telephone connection cable in the corresponding socket on the rear
side of the answering machine.
3. Plug the power adapter plug in a properly installed 230 Volt power outlet.
4. Connect the telephone connection cable supplied in the telephone line jack.
When switched on for the first time, the new answering machine requires approx. 3 seconds
to initialize all the functions. After the first initialization, your answering machine signals that
it is ready for operation by means of a signal tone and you can now set the day and time and
record your greeting message.

Defining the basic setting

Before putting the answering machine into operation, certain basic settings must be defined.
1. Press and hold the button u/SET for 2 seconds. You will hear the day of the week currently
set over the loudspeaker.
2. Press the button u/SET repeatedly until you hear the correct day of the week.
3. Press the button x/CHECK. You will hear an announcement of the hour currently set over
the loudspeaker.
4. Press the button u/SET repeatedly until you hear the correct hour announced.
22
a power adapter plug
an operating manual