Foreword; Safety Regulations - Cattini YAK20 Bedienungsanleitungen

Dear Customer, before using the jack, carefully read these instructions and become acquainted
with the safety symbols.
- This handbook is an integral part of the machine which must be kept safely and be handy for the
worker to consult whenever needed.
- The contents of this manual comply with Machine Directive 98/37 EEC and the jack is type ap-
proved in conformity with the European Norm EN 1494 and following amendments.
- The manufacturing company reserves the right to make modifications without prior notice and
without incurring any sanctions whatsoever, without prejudice to the safety and main technical
characteristics.
- Failure to observe the instructions may cause personal injury, which in some cases may be mor-
tal.
- The manufacturer is not liable for any damage to things or injury to people caused by an erro-
neous or incorrect use of its product.
The identification plate is on the side of the casing. DWG. 1
European certification mark
manufacturing year
- Only authorised personnel are allowed to use the equipment and they must know the
contents of this operating and maintenance handbook.
-The jack is an apparatus for lifting only and not for supporting, it is therefore absoltely
forbidden to work in any way under the vehicle being lifted until it is placed on the rela-
tive stands. DWG. 2
- Before starting to lift a vehicle it has to be blocked with the parking brake and/or by putting wed-
ges under the wheels, as illustrated in the figure DWG. 3
- If the vehicle is loaded check load stability when lifting.
- Place the jack so that the load is centred over it and where the gripping points are indicated by
the vehicle manufacturer.
- During lifting and lowering, it is necessary to check there are no persons or animals under the
suspended load or in the vicinity.
- Before lowering the load make certain the handle is in the horizontal position. DWG. 4
12

FOREWORD

type
capacity
working pressure
serial number

SAFETY REGULATIONS

Cattini Oleopneumatica S.r.l.
S.Ilario d'Enza (RE) - ITALY
Type:
Capacity:
Ton.
Working air pressure:
Year of manufacture:
Serial number
:
Made in ITALY
bar