Skoda TMB PS 026 Montage- Und Bedienungsanleitung Seite 44

- By means of four screws M10 x 35 (B), fasten the beams to the chassis of the
vehicle. Pull the towing coupling backwards from the vehicle and tighten the
screws on both sides (alternately) at the torque 70 Nm –detail-.
- 18, 19 -
- Check the fitting of the towing arm (C) in the clamping bush of the beam of the
towing coupling (see the Operation Manual of the towing coupling ).
- Fit the cover (F) into the clamping bush of the beam of towing coupling.
Next, proceed to the fitting of the electric installation of the towing coupling upon
the vehicle (see the instructions for fitting the electric installation of the towing
coupling).
Having finished the fitting of the electric installation, fit all the removed parts back to
their places and tighten the respective connections at the prescribed torque moments.
- 20 -
-
After the fitting has been finished, affix the self-adhesive label 50 kg (G) above the
cutting in the rear bumper (before affixing it, clean and degrease the place with the
de-greaser).
Advise the customer upon the following instructions
- 21, 22 -
- Clamp the cover of the hole in the rear bumper only after the glued bond is
strong enough (after 48 hours).
- After the fitting of the bumper, do not apply loads upon the loading edge of the
bumper before 48 hours from the gluing of the frame.
- Do not drive into any obstacles with the vehicle; do not lean it against another
vehicle (parking manoeuvres etc.).
- Within 48 hours after gluing the frame, do not go to a car wash.
44