Maintenance & Safety - Tokai CD-103 Bedienungsanleitung

PROGRAM METHOD
(1)Press the [PROG.] key at STOP mode, system will go to PROGRAM mode.
-The PRG icon and P01 will blink at 2Hz. This prompts the user to enter the first song in the program PLAY list.
(2)The user can select the desire tracks by using [NEXT], [BACK] keys.
Once these keys are pressed, the Display will show the selected track.
(3)After select the desired track, press [PROG.] key again and it will be stored in the memory. In Mp3 mode, Maximum 99 and
in CD mode, Maximum 20 tracks can be programmed when repeat steps (2) to (3) procedure.
(4)If press the [STOP] key during the program mode, then the selected TRACKs will be stored in the memory and return to
STOP mode (Continuous Play mode)
(5)If press the [PLAY] key during the program mode, it will start the program PLAY mode. Playback will start from P01 Track.
Erasing a program
You can erase the content of the memory by:
-Pressing the STOP button twice, while playing,
- Opening the CD door,
- Selecting another audio source mode.
MAINTENANCE & SAFETY
Precautions & General Maintenance
*Place the set on a hard and flat surface so that the system does not tilt.
*Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct
sunlight.
*Do not cover the set. Adequate ventilation with a minimum gap of inches between the ventilation
holes and surrounding surfaces is necessary to prevent from heating.
*The mechanical parts of the set contain self-lubricating bearings and must not be oiled or
lubricated.
*To clean the set, use a soft dry cloth. Do not use any cleaning agents containing alcohol,
ammoniac, benzene or abrasives as these may harm the housing.
Care of the cabinet
1.To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
2.The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use caution when cleaning
and wiping the plastic parts.
3.Mild soap and a damp cloth may be used on the front panel.
CD player and CD handling
*The lens of the CD player should never be touched!
*Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is
then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture
evaporates.
*Always close the CD door to keep the CD compartment dust-free. To clean, dust the
compartment with a soft dry cloth.
*To clean the CD, wipe in a straight line from the centre towards the edges using a soft
lint-free cloth. Do not use cleaning agents as they may damage the disc.
*Never write on a CD or attach any stickers on it.
33