Radio Operation - Tokai CD-103 Bedienungsanleitung

USE CLOCK
To setup the time of the unit
1. Connect the AC ON (The following operation must be in standby mode).
2. Short press on the TIME button, the time digits will be flashing on the LCD display.
3. Press BACK, NEXT buttons to select the time format display by 12h or 24h.
4. Press TIME button to confirm.
5. Then you can set the hour and the minute with the same method of steps 3-4.
ON/OFF TIMER
After setup the time of unit, long press on the TIME button can setup the unit ON & OFF time, with the same
method of steps 3-4.
Long press on TIME button "ON" will display 2 sec. then the digits of time will flash. Set the hour and
-
minute of the starting time with same method of steps 3-4.
Press TIME to confirm, then "OFF" will display 2 sec. then the digits of time will flash. Set the hour and
-
minute of the Power OFF Time of the unit with same method of steps 3-4.
Then the Audio source selection will flash : you can select Radio, CD, USB, SD, or AUX source with BACK
-
/ NEXT buttons, press TIME to confirm,
Then the Volume level selection will flash, select the suitable volume level with BACK/NEXT buttons and
-
press TIME to confirm.
After the settings are finished, the unit will show on the display the ON programmed time + OFF
-
programmed time + audio source + volume level, then return to normal Clock display.
RADIO
Radio reception
1. Press FUNCTION button select RADIO mode.
2. Tune to required station by press BACK or NEXT button.
Manual Tuning: Press BACK or NEXT and then release within 1 sec.
Auto Tuning: Press the play/pause button enter the automatic channel scan mode, and to be automatically
set.
To call back the auto preset channels, press Play/Pause button on the unit.
To Preset Channel :(FM 30 Preset memories)
(1) Press BACK or NEXT Select desired station.
(2) Press PROGRAM button once , the MEMORY number indicator begins steady in the display.
(3) Push PRESET- DOWN or PRESET-UP buttons (on the remote control) to select the desired number.
(4) Press PROGRAM button to save that station.
(5) Repeat steps (1) to (4) procedures to preset other stations.
3. After end of program. Press Play/Pause button to start play the frequency that you selected or press
number key on the remote control.
4. Push [VOL-]or [VOL +] to adjust the volume.
5. Extend ANTENNA wire to its full length to improve reception of FM broadcasting.
6. To turn OFF the radio press FUNCTION button to select another mode or press power button to switch OFF
the unit.
7. Switch ON again after shut down, the memory frequency still exists.
USE CLOCK

RADIO OPERATION

28