Rear Panel - VONYX CDP800 Gebrauchsanleitung

11. FILTER
Press to use sound filters
12. SKIP I<< AND >>I BUTTONS
Use this button to select the previous or next track
13. NUMBERED BUTTONS
When in sound effect mode:
1 = Air horn effect
2 = Siren effect
3 = Saxo effect
14. CUE BUTTON
While the unit is in playback, press PLAY/PAUSE button to pause the track. While the track is paused, press CUE to set the
cue point at the current position. The CUE indicator illuminates when the CUE point is set. Pressing CUE again will take you
to the cue point and pause the track
15. PLAY/PAUSE
Starts/resumes or pauses play
16. VOLUME CONTROL
Level: Adjust the output volume of the corresponding channel
Master: Adjust the volume of master output
17. TONE CONTROL
High: Adjust the high frequencies of the corresponding channel
Cue: Use this knob to select the channel you want to hear in your headphone for pre listening
Low: Adjust the low frequencies of the corresponding channel
18. LIGHT MODE BUTTON
Press once to turn on party lights, press twice to activate beat-sync light mode, press three times to power lights off
19. CROSSFADER
With this fader you can mix between left and right channels
20. HEADPHONE JACK
Connect your headphones
21. HEADPHONE VOLUME KNOB
Control the headphone volume

REAR PANEL

22. ON/OFF SWITCH
Switch to power the unit on or off
23. DC IN 9V
Socket for plugging in the supplied adapter
CONNECTING WITH BLUETOOTH
1.
2.
3.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
When in hotcue mode:
1 = hot cue point 1
2 = hot cue point 2
3 = hot cue point 3
Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "BT" button and activate BT-function.
Select "VONYX L or R" on your BT-device and make the BT-connection
5