Beko ATH7120 Bedienungsanleitung Seite 10

3 Operation instructions
Fit with the reservoir and tighten the lid (Fig. 3)
3.3 Operation instructions
After connecting the humidifier with the power supply, the indicator lights and the display turn on and
go out one by one, indicating the machine is energized. Press the power switch button (Fig. 5), the
power indicator lights, and the machine gets into the auto mode that it selects the rate automatically
according to the relative humidity of the current environment. At this time, the auto indicator and the
rate adjusting indicator both light. The display reads the current humidity. When the humidity is above
85% RH, the display reads H and the humidifier breaks off. The humidity of the environment will
decline gradually. When the humidity declines below 75% RH, humidifier starts to work again. When
the humidify is below 20% RH, the display reads L. When the humidity is below 75% RH, humidifier
produces heavier vapor. When the humidity is equal to or above 75% RH, it produces lighter vapor.
Press the rate adjusting button (Fig. 6) to set the machine to the manual operation mode instead of
auto, so that the auto adjusting indicator light goes out and you can adjust the rate manually. You may
select different humidifying modes or sleep mode according to the actual environment. Specifically,
in heavy vapor mode, the vapor is heavy, air rate fast and two sections of the indicator light; in light
vapor mode, the vapor is lighter, air rate faster and only one section of the indicator lights; and in sleep
mode, the indicators go out and only the display shows a moon. You may press any button other than
the power switch button to wake up the machine. Once waken up, the machine immediately produces
heavy vapor.
10 / 20 EN
Fig. 3
Fit the reservoir into the body
well in place (Fig. 4)
Fig. 4
Ultrasonic Humidifier / User Manual