INDASA E Serie Bedienungsanleitung Seite 29

ELECTRIC RANDOM ORBITAL SANDER
127 mm (5 in.) and 152 mm (6 in.)
STARTING AND STOPPING SANDER
1. Plug-in the sander's AC power cord to the power source (220Va.c. output). The warning "beep"
sounds would be occurred after the plug is securely plug-in to the power source and the LED indi-
cator shows " Solid Red " color at the moment.- see figure 1.
2. Press the power on/off button " Θ " on the button plate to switch on the sander. The LED indica-
tor shows "flash green" color after sander being switched on. - see figure 2.
3. Adjust the speed by pressing " + " or " - " buttons on the button plate. Press"+" is to
raise up to higher speed setting, "-" is to lower the speed setting. - see figure 3.
4. Press the lever to start running the tool. Release the Lever to stop the tool.
LED "flash green" LED "flash green"
Figure 1 Figure 2 Figure 3
MAXIMUM SPEED FUNCTION
The Electric Random Orbital Sander has seven preset Maximum Speeds (4000, 5000,
6000, 7000, 8000, 9000 e 10000/min (RPM)) The Maximum Speed can be changed at
any time while the Sander is running or when it is stopped.
Any setting for the Maximum Speed will be stored while the Power is turned "OFF".
MAXIMUM SPEED AND INTERMEDIATE SPEED CONTROL
1. Maximum Speed is adjusted by pressing the "+" or "-" buttons
on the buttrons plate of the Sander. Each touch will raise or
lower the speed to the next setting.
2. Intermediate speeds between Zero (0)/min (RPM) and
the set MaximumSpeed can be used with intermediate Le-
ver positions.- see figure 4
Figure 4
OVERLOAD PROTECTION SYSTEMS
The Electric Random Orbital Sander has two systems to protect the motor and circuit
board from overloading and overheating.
Downforce Overload System
The Sander has the ability to monitor and maintain the preset Maximum Speed as user
downforce increases or decreases during use. During periods of overly high user down-
force, the Sander will flash the LED on the back of the tool from Green to Red and cause
the motor to slow slightly as a warning to the user.Continuous downforce should be no
greater than approximately 5Kg (11 lb.). If the user continues with overly high downforce,
the Sander will change the LED to solid Red and stop. To restart the sander immediately,
released the lever and pressed down again and continue sanding. Repeated overloading
will result in frequent motor stops and increased tool temperature.
29