Marley STIR IT UP Gebrauchsanleitung Seite 5

LISTENING TO RECORDS
1. Connect the external amplifier device.
2. Place a record on the turntable, over the central spindle. Place the EP adapter
over the central spindle when playing 45 rpm records.
3. Set the Speed Selector to 33 or 45 rpm according to the record.
4. Release the tone arm clamp, and remove the needle cover from the stylus.
5. Lift the Tone arm with the Tone arm Lift Lever.
6. Move the tone arm to the beginning of the record, or to the start of a
particular track.
7. Gently lower the tone arm onto the record with the Tone arm Lift lever to
start playing.
8. When the record is finished the tone arm will automatically stop. To stop
manually, lift the tone arm from the record and return it to the rest.
NOTES:
• Remove the needle cover before you balance the tone arm.
• Hold tone arm whenever you make any adjustment or action so as to protect the
tone arm.
• Do not try to adjust the balance weight while playing a record as this could break
the needle and scratch the record.
• Re-secured the tone arm before transportation to protect the needle.
• Remove the balance weight before transportation to prevent damage or breakage
to the unit.
• Do not stop or turn the platter manually. Moving or jarring the turntable without
securing the Tone arm clamp could result in damage to the Tone arm.
ANTI-SKATING
Normally the anti-skating should be set to its minimum setting. Anti-skate com-
pensates for inward tracking forces that occur with certain pick-up when the stylus
nears the center of the record. If the turntable is experiencing excessive skipping
while nearing the center spindle, try increase the anti-skating in the increments
indicated on the dial. Start by adding an increment of 1, test its performance, then
increase it more, and so on.
NOTE: During adjusting the anti-skating knob, leave the tone arm and balance
weight alone to prevent damaging the stylus (needle).
EN