Marley STIR IT UP Gebrauchsanleitung Seite 3

POWERING YOUR STIR IT UP TURNTABLE
Your Stir It Up turntable uses an AC power supply and is powered by a standard
wall outlet.
1. Insert the AC power supply into Stir It Up.
2. Insert the wall plug into an appropriate wall outlet.
EASY TO USE
1. Connect the AC power supply to the household outlet.
2. Rotate the OFF / 33/45 knob to turn on the unit and Select the speed according
to the record you are playing.
3. Put a record on the turntable. Remember to use the 45 RPM adaptor located on
the top right corner when playing a 45 RPM record.
4. Lift and move the tone arm to turntable. Place the tone arm on the edge of the
record and the record starts playing.
5. Assemble the balance weight and set it to a proper position.
NOTE: The balance weight is to adjust the pressure of the needle. If the pressure is
too much, the sound will become distorted; if the pressure is too little, track skipping
will easily happen. Please adjust the balance weight by turning the balance weight
clockwise or counter-clockwise.
6. To pause or stop playing, you need to lift and move the tone arm back to the tone
arm rest manually.
7. When the end of the record is reached, the tone arm and rotation stop. Lift the
tone arm and place it to tone arm rest manually.
CONNECTIONS
CAUTION: Switch off the power to all equipment before making connections. Read
the instructions of each component you intend to use with this unit. Be sure to insert
each plug securely. To prevent hum and noise, avoid bundling the signal intercon-
nection cables together with the AC power cord.
LINE OUT OPERATION
1.Switch the PRE-AMP OFF/ON SWITCH to ON position.
2. Plug one end of the RCA cable (included) into the LINE OUT socket at the back
of the unit. Be sure to match the color with the socket.
3. Plug the other end of the cable into the LINE IN socket of your home
amplifier device.
4. Switch on the unit and the amplifier device you connected.
5. Adjust the volume on the amplifier device.
EN