Herunterladen Inhalt Inhalt Diese Seite drucken

Operating And Regulating The Machine; Maintenance; Warranty - Benassi AF 100 Betriebs- Und Wartungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 37

7-OPERATING AND REGULATING THE MACHINE

Before starting to use the leaf-sucker check the fixing of the suction opening.
Check the fixing of the bag and that the bag is not torn.
The machine (in the version AF 100) moves forward by manual drive.
It's possible to adjust the engine brake cable through the register ref. "H" fig.7.
When the vac-bag is full or very heavy, go next to the unloading area, switch off the engine, open
the zipper at the back of the bag (see Fig.11) and empty it. It is also possible to uncouple the bag
from the handlebar by lifting the two hands with hole from the pins (Ref. "I" Fig.14), and loosening
the belt (ref. "L" fig.12).
The height of the suction opening can be regulated easily through the knob (Ref. "M" Fig.13.). The
height van vary from 2 to 11 cm. from the ground, and it depends on the material that must be
sucked.
You can fix an accessory consisting of a flexible pipe ending with a stiff piece of pipe with knob
(fig.15.) if sucking must be carried out in narrow places inaccessible to the leaf sucker.
BEFORE PROCEEDING APPLY THE KIT SECTION PIPE TURN OFF THE ENGINE
In order to fix this accessory you have simply to apply the plastic catch and fix it through
the two issued knobs. Remove the cap in the front side of the opening and fix the flexible
pipe by means its
IMPORTANT !!!
IF THE LEAF-SUCKER IS USED IN VERY DUSTY PLACES IT MUST BE PERIODICALLY
CLEANED BY REMOVING THE DUST. THE OBSTRUCTION OF THE BAG DUE TO THE
DUST CAN CAUSE ITS BREAKING. DO NOT ASSEMBLE THE BAG IF IT IS WET. CARRY
OUT THE OPERATION ONLY WHEN THE ENGINE IS SWITCHED OFF.
For changing the oil and other maintenance operations on the engine (spark plugs, air filter,
regulations), refer to the engine manual provided.
A dirty or consumed plug can compromise the good working order of the engine. heck the plug
every 30 work hours. Keep the distance between the electrodes which should be equal 0,7 mm.
Clean periodically the bag from the dust. Do not assemble the bag if it is wet
The machines and accessories are guaranteed for 2 years, with the exception of electrical parts or
parts in rubber. The manufacturer shall replace pieces recognised as defective free of charge. Labour
and transport shall be at the expense of the purchaser. The warranty doesn't apply if the guaranteed
parts are defective due to wrong installation, tempering inaccurate use or carelessness. Warranty
request must be made through dealers authorised by the manufacturer.
With regard to materials not of our manufacture, with special reference to the motor, the rules laid
down by the respective manufacturers shall apply. Any request for repair shall therefore be directed to
the specific service centres in the respective areas.
For any problems or repair, contact the dealer where the machine was purchased.
19
strip.

8 MAINTENANCE

9

WARRANTY

A F 1 0 0

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für Benassi AF 100

Inhaltsverzeichnis