Keter GATE 4X6 Montageanleitung Seite 6

INSTALLING THE FENCE GATE
5
opening direction
INSTALLING THE GATE HINGES
6
1
T emporary base
min. 2" (5cm) high
6
sc35
(x4)
2
X2
s15b
18mm
(x3)
WHICH SIDE SHOULD THE
HINGES GO ON?
1. The main plate of the hinge
goes on the INSIDE of the gate.
sc40b
(x2)
2. Once you decide which side to
put the hinges on, mark their
positions on the gate (12 3/4" / 32
cm from the top & bottom of the
gate) and install
supplied screw.
requires 4 (sc35) screws on the
front plate, and 2 (sc40b) screws
on the side plate.
1. Position the assembled gate on
a temporary base (between 2"- 4" /
5-10cm high). Correct the timber
or blocks so that the gate is
horizontal and aligned with the
posts.
2. Fix the top hinge rst, followed
by the bottom hinge.
position of the hinge plate holes,
and attach the hinges to the post,
using screws.
s15b
18mm
(x2)
using the
Each hinge
Mark the
X2
Open the gate
& x the screw