Start-Up - P.Lindberg 9036627 Original Bedienungsanleitung

Start-up

• Fill the engine with engine oil.
• Fill the engine with petrol. Avoid overfilling.
• Replace the transport plug on the pump with the accompanying dipstick/cap.
• Check the oil level in the pump.
• Connect the high-pressure hose to the pump's outlet spigot.
• Connect the pistol, lance and optional nozzle to the high-pressure hose.
• Connect the water supply to the pump's inlet spigot.
• Start the engine.
• Regulate the working pressure on the regulator on the pump.
Important:
Always ensure that water is connected to the cleaner before the engine is started. A lack of
water even for a short period, can lead to serious damage to the pump seals.
If taking a break for more than two minutes, stop the engine.
Injector
Outlet spigot
Inlet spigot
Inlet filter
General information
The engine is equipped with an oil level sensor. The engine cannot start/operate if
there is not enough oil.
If chemicals are added, put the suction hose from the injector down into the
container. Replace the nozzle with a low-pressure nozzle since the injector only works
at low pressure. Mix ratio is 7:1. Ensure that plenty of water is run though the suction
hose, injector and the rest of the high-pressure side after use.
The pump is equipped with a safety valve to protect the machine.
P. Lindberg A/S
Tel.: +45 70212626
4
Sdr. Ringvej 1
6600 Vejen, Denmark
Regulator
Dipstick/oil filler cap
Engine oil plug
Safety relief valve
MAN 9036627_9050108 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk