KXPS320-KXPS640 24808730 19-02-14_- 24/02/14 12.14 Pagina 13
WARNING: cut off mains power before connecting the device to the
electricity mains!
Figure B shows the electrical connections diagram.
1. Connect the bus cable's red wire to the terminal's red connector (+) and the black wire
to the black connector (-). Up to 4 bus lines (wires of the same colour in the same
connector) can be connected to the terminal (figure F).
2. Insulate the screen, the electrical continuity conductor and the remaining white and
yellow wires of the bus cable (should a bus cable with 4 conductors be used), which
are not needed (figure D).
3. Insert the bus connector into the special pins of the device. The fastener guides
determine the direction it should be inserted. Insulate the bus terminal using the
relative cover, which must be screwed onto the device.
The cover guarantees that the power cables and the bus cables are separated by at
least 4 mm (figure G).
4. Connect the power supply to the relative screw terminals.
INSTALLATION
Electrical connections
13
E
N
G
L
I
S
H