Listening To The Radio - Teac mc dx40 Bedienungsanleitung

1 Press the FUNCTION button to select "Radio".
You can also use the FM/AM button to select "Radio".
<
2
Press the FM/AM button to select FM or AM.
3 Select the station you want to listen to (auto selection).
Hold down the TUNING/PRESET button (. or /) for more
than 0.5 seconds.
When a station is found, the tuning process will stop
automatically.
If you want to stop the tuning process, press the TUNING/PRESET
button (. or /).
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING/PRESET button (. or /) is pressed
momentarily (0.5 second or less), the frequency changes by a
fixed step.
Press the TUNING button repeatedly until the station you want to
listen to is found.
0

Listening to the Radio

FM MODE button
Pressing this button alternates between STEREO mode and
MONO mode.
1
2
3
Auto (stereo)
FM stereo broadcasts are received in stereo and the "St" appears
in the display.
If the sound is distorted the signal is not strong enough for good
<
stereo reception. In this case, it automatically changes to Mono
mode.
Mono
To compensate for weak FM stereo reception, select this mode.
"Mo" is displayed. Reception will now be forced to monaural,
reducing unwanted noise.
If the reception is poor
AM broadcast
Rotate or relocate the AM antenna to find the best position for
AM stations.
FM broadcast
Extend and rotate the FM antenna until you receive the stations
clearly.
In an area where FM signals are weak, it will be necessary to use
an outdoor FM antenna (see page 7).