Celestron TrailSeeker Anleitung Seite 8

adjUsting the leg angle
The legs of the TrailSeeker tripod can be set
at three different angles. To change the angle,
slightly push the leg in towards the center
column and pull out the leg angle adjustment
latch. Pivot the leg outward until it reaches
the end of its travel to obtain the widest angle
setting.
To use the middle setting, start at the widest
angle setting and slowly push the leg inward
while pressing on the leg angle adjustment
latch. When the middle angle setting is reached
the latch will depress and lock into place,
preventing it from pivoting outward.
To return to the standard leg angle, continue to
push the leg inward while pressing on the leg
angle adjustment latch until it locks into place.
The angle of each leg can be set independently
of the other two legs.
I ENGLISH
6
Note: The leg angle adjustment latch only prevents the legs from pivoting
outward. The tripod legs can always be pushed inward regardless of the
position of the adjustment latch.
Leg Angle Adjustment Latch
Fig. 6