European Union Compliance; Hazardous Locations; Explosion Hazard - AB Quality VersaView 6181H Installationsanleitung

European Union Directive Compliance
This computer meets the European Union Directive requirements when installed
within the European Union or EEA regions and has the CE mark. A copy of the
Declaration of Conformity is available at the Rockwell Automation website:
http://support.rockwellautomation.com under Product Certification.
ATTENTION
ATTENTION

Hazardous Locations

This equipment is suitable for:
• Class I, Zone 2, Group IIB, T3 Temperature Code (200 °C)
• Class I, Division 2, Groups C, D, T3C Temperature Code (160 °C)
• or non-hazardous locations
The following statement applies to use in hazardous locations.
WARNING
The temperature codes noted above are based on the computer operating ambient
temperature of 50 °C (122 °F). Do not install the computer in environments where
the explosive atmosphere (gas, dust, fibers) has an ignition temperature less than
the indicated temperature.
This computer is intended to operate in an industrial or control
room environment, which utilizes some form of power isolation
from the public low voltage mains. Some computer configurations
may not comply with the EN 61000-3-2 Harmonic Emissions
standard as specified by the EMC Directive of the European
Union. Obtain permission from the local power authority before
connecting any computer configuration that draws more than 75
watts of AC power directly from the public mains.
To comply with EN 55024, the Ethernet LAN cable must be less
than 30m [98.42 ft] long, and it must only be used indoors (i.e. not
exit the building at any point). All other I/O cables must be less
than 3m [9.842 ft] long, and must only be used indoors.

Explosion Hazard

• Substitution of components may impair suitability for
hazardous locations.
• Do not disconnect equipment unless power has been
switched off and area is known to be non-hazardous.
• Do not connect or disconnect components unless power
has been switched off.
• All wiring must comply with N.E.C. articles 501-4(b),
505-15(c) as appropriate.
• Peripheral equipment must be suitable for location it is
used in.
VersaView 6181H Integrated Display Computers
Publication 6181H-IN001B-MU-P
5