Axor Uno 27987 Series Gebrauchsanleitung Seite 4

EN 0 4
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and ⁄or
sensoric impairments must not use this product without
proper supervision. Persons under the influence of alco-
hol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive
body parts (such as your eyes). An adequate distance
must be kept between the shower and you.
The product may not be used as a holding handle. A
separate handle must be installed.
Shower hoses are only suitable for a connection from
the shower to the fitting. Never fit a shut-off device
between the fitting and the hose.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective coun-
tries must be observed.
⁄ During installation of the product by qualified trained
personnel, make sure that the entire fastening surface
is even and smooth (no protruding seams or tile offset),
that the finish of the wall is suitable to apply the product
and has no weak points.
⁄ With the excentric washer it is possible to equalize
tolerance of the drilling. (see page 31)
⁄ The premounted filter insert must be used to ensure
a normal flow of the shower and to prevent dirt from
entering through the pipes. Dirt entering can affect the
function and ⁄or lead to damages to the shower. Hans-
grohe will not be held liable for this type of damage.
⁄ Optimal functioning is only guaranteed with the com-
bination of Hansgrohe hand showers and Hansgrohe
shower hoses.
SPECIAL INFORMATION FOR THE USA
This unit does not include a wall supply. It must be used
with Hansgrohe model 27458xx3 or another approved
supply that complies with ASME A112.18.1/CSA B125.1
including ASME A112.18.3
A S S E M B L Y (see page 31)
T E C H N I C A L D A T A
Operating pressure:
Recommended operating pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
Do not use silicone containing acetic acid!
D I M E N S I O N S (see page 32)
O P E R A T I O N (see page 34)
C L E A N I N G (see page 36)
S P A R E P A R T S (see page 35)
XXX = Colors
000 = chrome plated
820 = brushed nickel
830 = polished nickel
930 = Polished Brass
S P E C I A L A C C E S S O R I E S (order as an
extra)
tile-matching-disk #96397XXX
(see page 35)
corner fitting set #28693XXX
(see page 35)
T E S T C E R T I F I C A T E (see page 35)
max. 0,6 MPa
0,1 - 0,4 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
max. 70°C ⁄ 4 min