Elko EP LIC-2 Bedienungsanleitung Seite 3

ELKO EP, s.r.o.
Palackého 493
769 01 Holešov, Všetuly
Czech Republic
Tel.: +420 573 514 211
e-mail: elko@elkoep.com
www.elkoep.com
Made in Czech Republic
02-70/2016 Rev.: 0
Characteristics
• serves as control unit for dimmers or electronic ballasts with analog control 0-10 V /
1-10 V
• keeps a preset lighting intensity (automatic regulation)
• control operating modes using existing button:
- switch OFF
- automatic regulation
- cleaning (maximum illumination level)
• setting the basic parameters of lighting is performed by potentiometers
- min. brightness of illumination
- maximum illumination level
- speed of dimming / illumination
• blocking the automatic control using external signal
• power supply AC 100 - 250 V
• 1-MODULE, DIN rail mounting
Description
1
2 9
10
3
4
11
5
12
6 13
7 14
8
* MIN - setting of min. brightness level (e.g. so energy-saving lamps do not go out during
regulation).
RUN - automatic regulation of lighting (brightness is maintained at the set value and
regulated using an illumination sensor).
SET - setting of the required level of illumination for automatic regulation.
In position SET and MIN, the brightness level is set by potentiometer P2 (green LED also
fl ashes). If the required brightness level is attained, the trimmer P1 is set to the RUN
position. The brightness level is thereby set (green LED lights up permanently).
** if the level of brightness on P2 is set on maximum the range is 24...120s
1. Inputs for illumination sensor
2. Analog output OUT (+)
3. Supply voltage indication
4. P1 - operating mode settings *
5. Speed of dimming / illumination **
6. Relay output
7. Supply voltage N
8. Blocking input B
9. Analog output OUT (-)
10. Output indication
11. P2 - brightness settings
12. Selection 0-10V / 1-10V
13. Supply voltage L
14. Control input T
LIC-2
Lighting intensity controller
Symbol
Connection
lighting sensor
OUT+
L
N
1 / 2
B L OUT+
IN1
IN2
V
T N OUT-
+
IN1 IN2
OUT-
–
L N
V L
N B T
EN