Kingston Technology DataTraveler Vault Privacy Anleitungen Seite 24

3. To initialize the DTVP, type the following command at the terminal prompt and press
./dtvp_initialize* (Remember, commands are case-sensitive.) See
ENTER:
4. After pressing
ENTER
to accept the license agreement and continue. (Note: If you press 'N' and do not accept the
license agreement, you will be returned to the terminal prompt and unable to continue the
initialization process until you repeat step 3 and press 'Y'.)
5. After you accept the license agreement, you will be prompted to input (create) a password,
which will be used to protect the files stored on the secure data partition. The password you
create must meet the following criteria before the initialization process will allow you to
continue:
a. Passwords must contain 6 characters or more (up to 16 characters.)
b. Passwords must contain three (3) of the following criteria options:
- UPPER CASE, lower case, numeric, and/or special characters (!, $, etc.)
6. Confirm your password by re-entering it on the command line when prompted to input it
again and press
been initialized successfully. If the passwords do not match, you will receive a message
indicating that you still need to confirm the password correctly. To do so, repeat steps 3
through 6 until they do.
After creating your password, a secure data volume (partition) will appear on the desktop. This
indicates that the initialization process was successful and is now complete. You may begin
using the DTVP.
*Note: Certain distributions of Linux will require super-user (root) privileges in order to execute
the DTVP commands properly in the terminal application window.
Document No. 48000012-001.A02
Figure 10.4 – Executing a DTVP Command
, the license agreement will display in the terminal window. Press 'Y'
. If the passwords match, you will be notified that the DTVP has
ENTER
DataTraveler
®
Vault - Privacy
.
Figure 10.4
Page 23 of 29