Remote Control - IBIZA LIGHT LZR430RGB 15-1567N Bedienungsanleitung

MANUAL - LZR Laser Show Systems
FUNC
Mode/Function: Set the operating mode of laser.
: Confirms all settings or changes of LED control panel.
ENTER
DOWN
UP
/ : Changes the operating mode, parameter or DMX address.
STAND ALONE PREPROGRAMMED LASER SHOW
•
Press FUNC to enter MODE OPTION.
•
Press UP or DOWN to select your favourite Stand Alone mode
•
Press ENTER to confirm the setting.
The laser is working in stand alone mode. Each time when you turn on your laser, you will have this confirmed
laser show. In the MODE OPTION setting, the stand alone laser show that you are going to choose, is flashing.
Press UP or DOWN to change stand alone laser show. You can choose among 21 different stand alone prepro-
grammed laser shows.
MASTER/SLAVE MODE
•
Press FUNC to enter MODE OPTION
•
Press the UP/DOWN buttons until the LED panel shows SLAV
•
Press ENTER to confirm the setting.
The laser is working in "SLAVE MODE". Connect MASTER laser and SLAVE lasers with DMX cable, the SLAVE
lasers do exactly what the MASTER laser does.
DMX MODE
•
Press FUNC to enter MODE OPTION
•
Press the UP/DOWN buttons until the LED panel shows D001.
•
Press ENTER to confirm the setting.
The laser is working in "DMX MODE". Change the DMX address of the laser via the UP/DOWN buttons.
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim
the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
REMOTE CONTROL (OPTIONAL)
1. AUTO Show
2. MUSIC show
3. Laser ON/OFF
4. Colour
5. Changing Pattern
6. Fixed pattern (from 1 to 128)
7. Pattern repetition

REMOTE CONTROL

1
2
3
4
5
A B C
1 2 3
6
4 5 6
7 8 9
-/--
7
0
www.ibiza-light.com
8.8.8.8.
FUNC
MENU UP DOWN ENTER
8888
d001
EN
5