IBIZA LIGHT LZR430RGB 15-1567N Bedienungsanleitung Seite 4

•
Secure fixture to fastening device using a safety chain.
•
Maximum ambient temperature (Ta) is 104° F (40°C). Do not operate the fixture at temperatures higher than
this.
•
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the near-
est authorized technical assistance centre. Always use the same type of spare parts.
•
Don't connect the device to a dimmer pack.
•
Make sure the power cord is never crimped or damaged.
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Don't expose your eyes to the light source while it is on.
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
LASER EMISSION DATA
As measured under IEC measurement conditions for classification.
Laser Classification ............................................................................................................................ Class 3B
Red Laser Medium ..................................................................................................LD GaAlAs 638nm, typical
Green Laser Medium ....................................................................................................DPSS Nd:YVO4, 532nm
Blue Laser Medium ....................................................................................................LD GeAs 445nm, typical
Beam Diameter .................................................................................................................. <5mm at aperture
Pulse Data ............................................................................................................All pulses < 4Hz (>0.25sec)
Divergence (each beam) ....................................................................................................................<2 mrad
Divergence (total light) ................................................................................................................<90 degrees
LASER POWER
LZR430RGB ..............................................................200mW-R-650nm +80mW-G-532nm +150mW-B-450nm
LZR250RGY .............................................................................................200mW-R-650nm +50mW-G-532nm
LZR300B .............................................................................................................................. 300mW-B-450nm
LZR80B .................................................................................................................................. 80mW-B-450nm
LZR150G ..............................................................................................................................150mW-G-532nm
LZR60G ..................................................................................................................................60mW-G-532nm
LZR200R .............................................................................................................................. 200mW-R-650nm
LZR250PINK ............................................................................................100mW-R-638nm; 150mW-B-445nm
SPECIFICATIONS
Mains Input ......................................................................................................................100-240V~ 50/60Hz
Fuse ............................................................................................................250V 2A Slow Blow (20mm Glass)
Total Power ................................................................................................................................................20W
Music Control .................................................................................................................. Internal microphone
Laser Safety Standard ........................................................................................................... EN60825-1 2014
Condition Temperature ...................................................................................................................... 10~40°C
DMX Connections ....................................................................................................... 3 pins XLR Male/Female
DMX Channels ......................................................................................................................... Max 9 channels
Measurement ...................................................................................................................250 x 210 x 105mm
Weight ....................................................................................................................................................1.5 Kg
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit
is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can
hold 12 times the weight of the unit when installing the fixture.
CONTROLS & FUNCTIONS
When the unit is powered on, the LED monitor on rear panel shows the current operating standalone mode or
DMX address of DMX mode. The LED control panel allows setting and changing the operating mode of the laser
very easily. After every reset or save, the new mode information will be shown on the LED monitor at next power
on.
4
MANUAL - LZR Laser Show Systems
INSTALLATION
©Copyright LOTRONIC 2019