Emos 98103 Bedienungsanleitung Seite 2

DOOR CHIME type 98103
GB
The set includes a push button (transmitter) and a home door chime (receiver). The door chime is designed
for a permanent connection to a grid with voltage of 230 V AC/50 Hz.
A transmission between the button and the door chime is performed by radio waves at frequency of 433,92 MHz.
Transmission range depends on local conditions and can be up to 100 m in an open space without interference.
For a correct use of the wireless door chime, read the user manual carefully.
Specifi cations
Transmission range: up to 100 m in open area (in built-up area may drop to fi fth)
Pairing of the door chime and the push button: "self-learning" function
Push button: waterproof, cover IP44
Pairing capacity: max. 16 buttons
Optical signalization of ringing on push button
Number of melodies: 16 melodies
Transmission Frequency: 433,92 MHz
Power of door chime unit: 230 V AC/50 Hz
Power of pushbutton: Battery 1 × 12V (Type A23)
Included parts: double-sided adhesive tape, 2 screws
A – Melody selection
COMMISSIONING
Push button of the door chime (transmitter)
1. Using a screwdriver remove the back cover through the hole on the side of the button. Insert 12V battery
in to the button. Pay attention to the polarity of the inserted battery.
2. Attach the back cover that serves as a holder on a wall with two screws. It can also be attached using double-
sided adhesive tape. Check if the set operates reliably at a chosen place before installation. It is advisable
to choose a protected position of the button, e.g. placing it in an embrasure.
3. Assemble the button by putting the front part on the back cover and snap it.
4. Write your name on the label under the transparent cover.
Remove the cover by slight pulling.
Note: The push button of the door chime (transmitter) can be easily placed on wood or brick walls.
Never place the button directly on metal objects or materials that contain metal such as plastic construction of
windows and doors that contain metal frame. The transmitter may not function properly.
Pairing of the push button and the door chime
1. Plug the door chime in a socket 230 V AC/50 Hz, hear a melody, the door chime is ready for pairing.
2. Press the push button on the button (transmitter), hear a melody, the devices will be matched.
3. For pairing of other buttons, repeat step 2.
P5721_manual-A6.indd Spread 2 of 14 - Pages(2, 27) P5721_manual-A6.indd Spread 2 of 14 - Pages(2, 27)
1 - Replacing of a battery in the push button
2 - Installation of the button
1. 2.
2 27
11.03.14 12:50 11.03.14 12:50