Tuning To Radio Stations - Philips mz 3 Benutzerhandbuch

CD player and CD handling
• If the CD player cannot read CDs correctly, use a
commonly available cleaning CD to clean the lens before
taking the set to repair. Other cleaning methods may
destroy the lens.
• The lens of the CD player should never be touched!
X
• Sudden changes in the surrounding temperature can
cause condensation to cloud over on the lens of your CD
player. Playing a CD is then not possible. Do not attempt
to clean the lens but leave the set in a warm
environment until the moisture evaporates.
• Always keep the CD compartment closed to avoid dust
on the lens.
• To take a CD out of its box, press the centre spindle
while lifting the CD. Always pick up the CD by the edge
and return the CD to its box after use to avoid
scratching and dust.
• To clean the CD, wipe in a straight line from the centre
towards the edge using a soft, lint-free cloth. Do not use
cleaning agents as they may damage the disc.
• Never write on a CD or attach any stickers to it.
10
TUNER
MC 158 COM MC 158 COM
PAC T AUD IO PAC T AUD IO
IO IO
IO IO SYS TEM SYS TEM
IO IO
II II
IO IO
II II
IO IO
II II
IO IO
IO IO
I II I II

Tuning to radio stations

1 Select TUNER source.
™ TUNER is displayed briefly.
2 Press BAND (or SOURCE on the set for 2 or more
seconds) to select your waveband.
3 To tune to a station, press TUNING ¡1 or 2™ (on the
remote control 11 or 22 ) and release when search
tuning starts.
™ The radio automatically tunes to a station with
sufficient reception. Display indication during
automatic tuning: SEARCH.
™ If a FM station is received in stereo,
shown.
4 Repeat step 3 if necessary until you find the desired
station.
• To tune to a weak station, press 5 or 6 briefly and
repeatedly until you have found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations in the
memory.
OPEN OPEN
CLOSE CLOSE
Automatic programming
PRESET PRESET
Automatic programming will start with a chosen preset
number. From this preset number upwards, former program-
med radio stations will be overwritten. The unit will only
TUNING TUNING
programme stations which are not in the memory already.
1 Press PRESET 4 or 3 (¡ or ™ on the remote control) to
select the preset number where programming should
start.
Note: If no preset number is selected, default is
preset 1 and all your presets will be overwritten.
2 Press PROGRAM on the set or remote control for more
than 2 seconds to activate programming.
™ AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW (AM) and then LW. The
last preset automatically stored will then be played.
™ Press 9 on the set to interrupt auto programming.
Manual programming
1 Tune to your desired station (see Tuning to radio
is stations).
STEREO
2 Press PROGRAM on the set or remote control to activate
programming.
™ PROGRAM flashes in the display.
3 Press PRESET 4 or 3 (¡ or ™ on the remote control) to
allocate a number from 1 to 40 to this station.