Medicura m287 Bedienungsanleitung Seite 10

ATTACHMENTS
a – Polishing cone bit
b – Fine-grain cone bit
c – Tapered file bit with a wide tip
d – Fine-grain disc bit
e – File bit with a tapered tip
f – File bit with a cylinder tip
g – File bit with a round tip
This product has been manufactured in conformity to current
2006/95/EC and 2004/108/EC.
Technical data indicated on the appliance.
INSTRUCTIONS FOR USE
>GB
The appliance is equipped with 2 speeds and 2 directions of rotation.
Select one of the interchangeable accessories and begin the treatment
by positioning the switch on the desired speed and direction of rotation.
In order to ensure an optimum performance it is advisable not to wash
the feet or hands before the treatment.
Once the treatment is finished, r inse the treated par ts.
Whenever you need to change the accessory make sure that the appliance
is switched off.
It is advisable to keep the appliance switched off for at least 15 minutes
after finishing a 20 minutes operating cycle.
WARNING!
Stop the treatment at regular intervals to verify the results obtained up
to that moment.
This is recommended particularly in the case of diabetics since sensitivity
in their limbs may be impaired.
Accessory functions.
Fine-grain disc bit: to file thick and hard nails
Fine-grain cone bit: to file thick and hard corns
Tapered/round/cylinder file bit: to file the corners of nails
Tapered file bit with a wide tip: to file the corners of nails
Polishing cone bit: to round off nails and polish their surfaces.
10