Klarstein ShirtButler Deluxe Handbuch Seite 16

EN
16
Using the Timer
1. Insert the power plug into power socket.
2. Turn the timer knob clockwise until the machine starts to work, the power indicator
will illuminate.
3. Rotate the knob to preset the timer. When the set time elapses, the device switches
off automatically. The drying/pressing process can be interrupted at any time by
turning the timer to the starting position.
TROUBLESHOOTING
Problem
The device is not running.
The LED does not light up.
Unusual noises.
The unit goes out suddenly. • Are the wind outlet covered up or blocked? Free up
Odour.
Possible cause and suggested solution
• Is the mains plug inserted in the plug socket
correctly? Correct the fit of the mains plug.
• Is the plug socket defective? Try another plug
socket.
• Check the fuse of the mains connection.
• Is the device switched on? Set the timer to a time.
• Are the wind outlet covered up or blocked? Free up
the outlet vent.
the outlet vent.
• The device has an automatic safety switch-off
function. It switches off automatically if it overheats.
Allow the device to cool down and switch it on
again.
• You might notice a slight odour caused by
production residues the first time you use the device.
However, this is harmless and will cease as you use
the device.