Troubleshooting - Klipsch SB 120 Bedienungsanleitung

TROUBLESHOOTING

SB 120 will not Power On
• Is it plugged into a live outlet?
• Is the rear power switch on?
No sound
• Is it plugged into a live outlet and the rear power switch is on?
• Are all cables from the TV/Cable Box/Satellite Box plugged in tightly?
• If the optical cable is being used were the clear plastic caps from both ends
removed before connecting?
• Is the volume turned up?
• Is standby off (no SOLID RED status light)?
• Is the source input correct?
• Turn off the rear power switch, then back on.
TV/Cable/Satellite Box Remote will not program
• Carefully follow all remote programming instructions.
• Carefully go through the remote programming again, but use the original
remote that comes with the TV. You DO NOT need to then reprogram using
your cable/satellite/universal remote control.
• Program the original TV remote to the SB 120 (if original is a different one),
then use the universal remote without programming it.
• You may need to repeat programming of a function in some cases.
• There may be some cases the SB 120 is unable to learn certain remote codes.
Bluetooth does not work
• Is the device paired to the SB 120?
• Move your device closer to the SB 120 and make sure it is paired.
• If the status light blinks RED while attempting to pair, start the pairing
process over.
Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are registered
trademarks of Dolby Laboratories.
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Klipsch Group, Inc. is under license.