Dip-Switches And Connectors; Video Channel Connection; Optical Fibre Connection; Data Channel Connection - Videotec FOTX Bedienungslanleitung

6.1.1 Dip-switches and connectors

S
VIDEO
TX/RX
+
2 WAY DATA
LINK
VIDEO
DATA IN
DATA OUT
Dip-switch
POWER
Fig. 1

6.1.2 Video channel connection

Connect the video cable to the VIDEO IN/OUT connector (Fig. 1, page 5).

6.1.3 Optical fibre connection

Connect the optical fibre (Single Mode/Multi Mode) to the OPTICAL IN/OUT connector (Fig. 1, page 5).

6.1.4 Data channel connection

6 types of configuration are possible depending on the data transmission/reception standard.
The dip-switch and clamps of the connector are described in the relative picture (Fig. 1, page 5).

6.1.4.1 Up The Coax (UTC)

The data flow is transmitted via the Video Channel. No connections to the data connector are required (Fig. 1,
page 5).
1 2
ON
ON ON
Fig. 2
Up-The-Coax
receiver
Remote equipment
Fig. 3
M
DATA
DOUT
DIN
GND
DIN+
DIN-
DOUT+
DOUT-
A
ON
B
PWR
GND
+Vin
VIDEO IN
FOTX
Standard ST connector
(Optical fibre)
BNC (Video)
Data connector
Power connector
VIDEO IN
FORX
Up-The-Coax
transmitter
Remote equipment
5